4. Special Functions
Introduction
You can perform a number of other functions, apart from setting and unset
ting the system. These functions are:
[Access code] + X
Setting the system so that some zones are by
passed or omitted.
[Access code] + 3
Setting the time and date on the system's internal
clock.
[Access code] + 4
Changing access codes.
[Access code] + 5
Reading the system log.
[Access code] + 7
Turning the chime function on or off.
[Access code] + 8
Testing the sounders.
[Access code] + 9
Testing the zones.
To use these functions you must key in your access code and then press a
number key. The rest of this section describes each function in turn.
Omitting Zones
Your system may be programmed so that you can omit individual detectors
when setting the system. Ask your Installer which zones can be omitted. Note
that omission is not permanent. You must omit the zone every time you set
the system.
To set with a zone omitted:
1.
Key in your access code.
2.
Press the appropriate Level key, and then within 5 seconds:
3.
For zones 1 to 9 press X (Omit) followed by the number(s) of the
zone(s) you want to omit (for example, key in X(Omit) 2 to omit zone 2).
For zones 10 to 16 press X (Omit) twice followed by a number 0 to 6
(for example, key in X (Omit) X (Omit) 2 to omit zone 12).
The display shows the zone number of the detector that will be omitted.
The system carries on to set as normal. The system will not raise an
alarm if the omitted zone is triggered. Note that the next time you set the
system the zone will operate as normal; omission only lasts for one
setting/unsetting cycle.
12
496247 Issue 4
