Scanreco RC400, Instruction Manual

Page: 26 / 40

Document type Document number Rev Page
Manual 66024
C 25 of 37
4 Safety regulations and operating
instructions
4.1 Safety regulations
These instructions cover those special regulations which apply for remotely controlled
cranes (cable or radio). The driver must be aware of the contents of these safety
regulations.
Remote controlled cranes may only be operated by trained personnel. The portable
control unit must never be passed over to any person who has not received training
for remote controlled cranes. If these instructions are not followed, serious accidents
can occur.
THE OPERATOR MUST:
•
Check that the control unit matches the crane / machine which he is to operate.
•
Acquaint himself with the symbols and positions for operating functions and
directions.
•
Every time before starting work, check the stop function on the portable
controller unit by doing the following:
1. Operate a crane / machine function and press the stop button on the portable
controller unit. The crane must immediately come to a standstill. No further
crane movements are possible.
2.
If the cranes movement is not interrupted, crane operation must be stopped
immediately and a service workshop visited.
•
During operation, walk or stand at a suitable distance from the crane to be able
to get a good view of the operation. No unauthorised persons may be within the
crane's working area.
•
Be aware that it is forbidden to convey loads over himself or fellow workers.
•
Release all manoeuvre levers (dead-man's-handles) if crane movement control is
lost and then immediately press the stop function on the control unit and the
emergency stop on the crane.
•
The stop function on the control unit should always be in the depressed position
whenever the unit is not in use. This applies even for short stoppages, for
example, if the driver wishes to move.
•
After a completed run, press the stop function on the control unit and on the
crane. The control unit must be kept out of reach of unauthorised persons.
•
Always report equipment faults or shortcomings to the person responsible for the
crane.
•
Check that none of the safety devices have been altered or removed.
•
Refer to the current regulations / instructions regarding "Personnel lifting with
cranes”, “Overloading/overload protection ", "Visible signals during the operation
of cranes" and "The location of cranes close to airports and high-tension power
lines".
•
Be aware of any other pertinent regulations and of any local regulations which
may apply. These are to be found in the relevant safety regulations regarding
crane transport.
25/37