SCANMASKIN 32 PROPANE, Manual

Page: 30 / 60

30
www.scanmaskin.com
Follow these steps to replace the grinding head plate
• Make sure the machine is in its “Safety off position”
• Tilt the machine backwards and secure it.
• Remove any tools used.
• Loosen the two screws holding the grinding head.
• Put the plate upside down and loosen the bolts that holds the spring steel discs
• Replace the grinding head or spring steel discs.
• It’s recommended that new screws are used to fasten the replacement Grinding head plate.
• Tighten all screws by hand and make sure that they are secured.
5.5 Cleaning the machine
Before starting to clean the machine, make sure it is in its” Safety off position”
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap are recommended.