![background image](http://html1.mh-extra.com/html/scag-power-equipment/sfz61-30bs/sfz61-30bs_operators-manual_1205827030.webp)
26
R
Section 6
ADJUST HERE
LOOSEN HERE
2012 SFZ RSDA
Cutter Deck Pitch Adjustment
Figure 6-6.
- Note -
To prevent the cutter deck from teetering, all four
(4) cutter deck hanging chains must have tension
on them. If all four chains do not have tension on
them and the deck teeters, you must readjust the
cutter deck as outlined in the procedures above.
All measurements should be taken from the top
edge of the deck as the deck has an uneven
bottom edge.
CUTTER DECk HEIGHT
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck height,
be sure that the mower is on a flat, level surface and the
tires are properly inflated.
Place the cutter deck in the 3" cutting position. Push
1.
on the cutter deck foot pedal and pull up on the
cutter deck release lever to lower the cutter deck.
Check the measurement from the floor to the
2.
cutter blade tip. If the measurement is not 3", an
adjustment can be made using the deck level links
Loosen the elastic stop nuts securing the deck level
3.
links on both sides of the cutter deck. See Figure
6-7.
2012 SFZ DLA
LOOSEN HERE
ADJUST HERE
2012 SFZ RSDLA
LOOSEN HERE
ADJUST HERE
Cutter Deck Height Adjustment
Figure 6-7.
Turn the adjustment bolts equal amount of turns
4.
either clockwise to raise or counter-clockwise to
lower the cutter deck until the measurement at the
cutter blade is 3" on both sides..
Tighten the elastic stop nuts on the deck level links.
5.