![background image](http://html1.mh-extra.com/html/scag-power-equipment/sfz61-30bs/sfz61-30bs_operators-manual_1205827017.webp)
13
R
Section 4
Hourmeter (Figure 4-1).
6.
Indicates the number of
hours the engine has been operated. It operates
whenever the engine is running. Has preset
maintenance reminders for engine and hydraulic
system oil changes. Will start flashing scheduled
maintenance 2 hours before preset time and
continue flashing until 2 hours after. Automatically
resets.
Fuse Holders (Figure 4-1).
7.
Two 20-amp fuses
protect the mower’s electrical system. To replace
fuses, pull fuse out of the socket and install a new
fuse.
Left Steering Control (Figure 4-1).
8.
Used to control
the mower's left wheel when traveling forward or
reverse.
Right Steering Control (Figure 4-1).
9.
Used to
control the mower's right wheel when traveling
forward or reverse.
Brake Pedal (Figure 4-1).
10.
Depressing the brake
pedal applies the brake.
Parking Brake Lock Latch (Figure 4-1.
11.
Used
to lock the parking brake in the engaged position.
Fully depress the brake pedal and pull the parking
brake lock latch back to lock the parking brake in the
engaged position. See Figure 4-2. Fully depress the
brake pedal forward to disengage the parking brake
lock latch, then release the brake pedal to disengage
the brake. See Figure 4-3.
PUSH BRAKE
PEDAL FORWARD
PULL BACK ON
PARKING BRAKE
LATCH
engaging the Parking Brake
Figure 4-2.
PUSH BRAKE PEDAL
FORWARD THEN RELEASE
PEDAL TO DISENGAGE
Releasing the Parking Brake
Figure 4-3.
Dump valve Control Levers (Figure 4-4).
12.
Located
on the left and right side of the bumper, used to
“free-wheel” the mower. Rotating the levers forward
into the notch (towards the front of the mower) allows
the unit to move under hydraulic power. Rotating the
levers backward to the notch (towards the rear of
the mower) allows the mower to be moved by hand
(free-wheeling).
DUMP VALVE
CONTROL LEVER
"FREEWHEEL" POSITION
"DRIVE" POSITION
2012 SFZ DVL
Dump Valve Control
Figure 4-4.
Deck Lift Foot Lever (Figure 4-1).
13.
Used to raise
and lower the cutter deck.
Cutting Height Adjustment (Figure 4-1).
14.
Used to
set the cutter deck at the desired cutting height.
Deck Release Lever (Figure 4-1).
15.
Used to lock the
cutter deck in the transport position. Push the foot
pedal forward and pull back on the release lever to
release the cutter deck for normal mowing.