![background image](http://html1.mh-extra.com/html/scag-power-equipment/sfz61-30bs/sfz61-30bs_operators-manual_1205827022.webp)
18
R
Section 4
The discharge chute must not be removed and
2.
must be kept in the lowest position to deflect grass
clippings and thrown objects downward. Direct the
side discharge away from sidewalks or streets to
minimize cleanup of clippings. When mowing close
to obstacles, direct the discharge away from the
obstacles to reduce the chance of property damage
by thrown objects.
Cut grass when it is dry and not too tall. Do not cut
3.
grass too short (cut off 1/3 or less of existing grass
for best appearance). Mow frequently.
Keep mower and discharge chute clean.
4.
When mowing wet or tall grass, mow the grass twice.
5.
Raise the mower to the highest setting for the first
pass and then make a second pass to the desired
height.
Use a slow travel speed for trimming purposes.
6.
Operate the engine at full throttle for best cutting.
7.
Mowing with a lower RPM causes the mower to tear
the grass. The engine is designed to be operated at
full speed.
Use the alternate stripe pattern for best lawn
8.
appearance. Vary the direction of the stripe each
time the grass is mowed to avoid wear patterns in
the grass.
ADJUSTING CUTTING HEIGHT
4.13
The mower deck can be adjusted from a height of 1 inch
to 4-1/2 inches at 1/4-inch intervals. To adjust the cutting
height:
WARNING
DO NOT adjust the cutting height with the mower
blades rotating. Disengage the power to the cutter
blades and then adjust cutting height.
Disengage the power to the cutter blades.
1.
Push the cutting height adjustment foot pedal all
2.
the way forward using your right foot until it locks in
place. See Figure 4-6.
CUTTER DECK
RELEASE LEVER
CUTTING HEIGHT
ADJUSTMENT
DECK LIFT
2012 SFZ CDHA
Adjusting Cutting Height
Figure 4-6.
Insert the pin into the cutting height index at the
3.
desired cutting height. Push forward on the deck
lift foot lever, hold in place and lift up on the deck
release lever. See Figure 4-6. Slowly release the foot
pedal. A deck height decal is located on the cutting
height index as an aid in adjusting the deck to the
desired height. See Figure 4-6.
TOWING (OPTIONAL HITCH
4.14
ACCESSORY)
NEVER allow children or others in or on towed
1.
equipment.
Tow only with a machine that has a hitch designed
2.
for towing. Do not attach towed equipment except at
the hitch point.
Follow manufacturer's recommendations for weight
3.
limit for towed equipment. 250/lbs. maximum towing
weight.
NEVER TOW ON SLOPES. The weight of the towed
4.
equipment may cause loss of traction and loss of
control.
Travel slowly and allow extra distance to stop.
5.
Zero-turning with a trailer attached could cause
6.
damage to the trailer or mower.