![background image](http://html.mh-extra.com/html/scag-power-equipment/cheetah-ii/cheetah-ii_operators-manual_1205794028.webp)
22
R
Section 4
4.16 ADJUSTING THE HEIGHT ADJUST
PEDAL
1. Position the seat to the desired location.
2. While in the operator's position without the engine
running, push down on the height adjust pedal to
check for full function control.
3. The height adjust pedal can be located in three (3)
different positions for operator comfort and control.
See Figure 4-8.
HEIGHT ADJUSTMENT PEDAL LOCATIONS
Figure 4-8. Height Adjust Pedal Locations
4.17 ADJUSTING THE STEERING LEVERS
1. Position the seat to the desired location.
2. While in the operator's position without the engine
running, move both steering levers forward and
reverse to check for full function control and comfort.
3. If adjustment of the steering levers is needed, use
the following instructions to adjust.
A. Loosen the tension knob on the lever assembly.
B. Rotate the steering lever forward or backward to
achieve the optimum operating position.
C. Tighten the tension knob and repeat on the opposite
side.
D. While in the operator's position, bring the steering
levers out of the neutral lock position and check to
make sure both levers are even before operating.
TENSION
KNOB
TENSION
KNOB
ROTATE
LEVER
Figure 4-9. Adjusting Steering Levers
4. The control handle can also be adjusted in two
different height positions. If necessary, remove the
two bolts securing the control handle to the control
lever. Install the handle in the desired position.
4.18 SETTING THE SPEED CONTROL
The speed control lever can be set in either LOW or HIGH
range. Moving the speed control lever between LOW and
HIGH range sets the maximum forward/reverse speed the
machine can obtain during operation. See Figure 4-10.
Speed Control Selection Recommendations
LOW Range (Forward Travel Speed = 0 up to 12 mph)
-
Recommended for best overall cutting performance in
all conditions.
HIGH Range (Foward Travel Speed = 0 up to 16 mph)
-
Recommended for transport. Although the machine is
capable of engaging the mowing deck in HIGH Range,
overall quality of cut may suffer. If the material being cut
is sparse or dormant, HIGH Range can be selected to
"knock down" tall weeds, seed heads, etc. However for
best overall cut performance, it is recommended to select
LOW Range for mowing.
SPEED CONTROL
LEVER
Figure 4-10. Speed Control Lever
Summary of Contents for CHEETAH II
