![background image](http://html.mh-extra.com/html/scag-power-equipment/cheetah-ii/cheetah-ii_operators-manual_1205794045.webp)
39
R
Section 7
7.5 ENGINE FUEL SYSTEM
DANGER
To avoid injury from burns, allow the mower
to cool before removing the fuel tank cap and
refueling.
A. FILLING THE FUEL TANKS
Fill to the bottom of the filler neck insert (approximately 8
gallons per fuel tank indicating Full (F) on the fuel gauge)
at the beginning of each operating day. See Figure 7-6.
Do not overfill. Use clean, fresh unleaded gasoline with
a minimum octane rating of 87 and a maximum of 10%
Ethanol.
DO NOT use E85 Fuel. Using E85 Fuel will cause severe
damage to the engine.
FUEL LEVEL
FILLER NECK
INSERT
E
F
1/4
1/2
3/4
. .
.
.
.
Figure 7-6. C.A.R.B. / EPA Phase 3 Fuel Level
To avoid personal injury or property damage, use
extreme care in handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
1. Extinguish all cigarettes, cigars, pipes and other
sources of ignition.
2. Use only an approved gasoline container.
3. Never remove the gas cap or add fuel with the
engine running. Allow the engine to completely cool
before fueling.
4. Never fuel the machine indoors or in an enclosed
trailer.
5. Never store the machine or fuel container where
there is an open flame, spark or pilot light such as on
a water heater or other appliances.
6. Never fill containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place
containers on the ground away from your vehicle
before filling.
7. Remove the machine from the truck or trailer and
fuel on the ground. If this is not possible, then refuel
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
8. Keep the nozzle in contact with the rim of fuel tank
or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
9. If fuel is spilled on clothing, change clothing
immediately and wash affected skin.
10. Replace gas cap and tighten securely. Tighten the
fuel cap until it ratchets.
B. REPLACING IN-LINE FUEL FILTER
ELEMENTS
The engine fuel filter should be replaced after every 500
hours of operation or annually, whichever occurs first. See
Figure 7-7.
1. Close the shut-off valve.
2. Remove and replace the engine fuel filter. Open the
fuel shut-off valve.
Summary of Contents for CHEETAH II
