SC2000 PTA1587X, User Instruction

Page: 24 / 28

-21-
Faults
Phenomenon
There is no
action and
no image after
powered up
There is image,
but do not
self-test when
powered on
There is no
image, but can
do self-test after
powered on
There is image,
and can do
self-test,
but can not
control after
powered on
Video image
is Foggy
Check part
Check power adapter
and power PCB
Motor has abnormal sound
PTZ Swings
Connection line between
power panel and
connection panel
Video line, BNC Connector
RS485 communicate line
N/A
Transparent cover
Probable Cause
Power adapter
Power circuit exist has problem
Mechanical problem
Very incline
Power is not enough
Something wrong with motherboard
Do not insert properly
Do not install contact properly
Something wrong with the circuit
Irregular operation leads
to out of control
Something is wrong with
the motherboard
Speed dome camera is
in state of manual focusing
Transparent cover is dirty
Solution
Change power supply
Replace
Overhaul if it get stuck in something
Set it straight
Change a new power supply that
meet the requirements
replace
Insert again and push protective cover
Make sure all connection is proper
Make sure all connection is proper
Power off and restart
replace
Operate speed dome camera
or call any one preset to make
it back to auto. focusing
Clean transparent cover
4.1 FAQs
Chapter 4
Appendix
A
p
p
e
n
d
ix
N/A
N/A
N/A
4.2 Clean the Transparent Cover
In order to make the image clear, the cover need to be cleared timely.
When clear, please be careful for avoiding to touch the transparent cover directly, the
acid sweat of the human finger may rust the surface of the cover. The scratch of the
flint to the transparent cover will lead to foggy image, affect the image quality.
Please use soft enough dry cloth or other replacement to wipe the inner and surface.
If seriously dirty, can use neutral cleanser, any high grade furniture cleanser can used
to clean the transparent cover.