Document
9911004rev27
Title
Date
2017-02-16
Page
55(81)
SBS MicroSMART Battery Charger Technical Handbook
Change the values of
Power unit
and
Idc max
according to the sticker on the charger.
See
5.5.15 Factory settings
for more information. Note that the values for
Iac
and
Pac
seen here are default values. This means that if the current for example will have an
amplitude of more than 16 A it is necessary to change this value. To change the
parameters, follow the tutorial
Edit parameters.
In the picture below
Iac
has been
changed to 32 A and Pac to 20000 W.
Press ESC to return to the service menu.
3.
You are also going to be required to adjust the parameters found under
Charging
param
in the service menu. While in the service menu put the marker on
Charging
param
and press
OK
. The following menu is now shown.
Here it is possible to change options regarding how the charge should be carried out.
See
5.5.2 Charging param
for more information. Change the options in the
Charging
param
menu to be suitable for the type of battery being used. To change a value put
the marker on the parameter you would like to change and follow the tutorial
Edit
parameter
in order to change it. Press
ESC
to return to the service menu.
4.
The next step is to calibrate the charger. While in the service menu put the marker on
Calibration
and press
OK.
See the tutorial
Calibrate the charger
for more information.
5.
Make sure the
Charger ID
is the same as the serial number of the charger which can
be found on a sticker at the bottom of the charger. To edit the
Charger ID
go to the
Radio menu found under Service. The following menu is shown.
