33
RT-TGP/RT-BT OWNER’S MANUAL
11
12
13
Repeat the previous step for the holes
in the rear rail and rear edge of the
router table. Use a 5mm hex wrench
and a 13mm wrench to tighten the hex
nuts.
Adjust the feet in the support legs until
they contact the ground and keep the
cast iron table level. Then use a 13mm
wrench to tighten the hex nuts (3.2) up
against the bottoms of the support legs.
See your table saw fence manual for instructions on how to re-tighten the hardware
securing your rear rail to your table saw and how to reinstall the main tube. It is very
important to install and align the main tube correctly.
Congratulations! You have completed the In-Line Right: Between PCS 36” Rails Installation.
Continue to page 40 for the next steps.
3.2
