28
RT-TGP/RT-BT OWNER’S MANUAL
1
If you are installing the intermediate cast iron wing, proceed to step 2 below.
Otherwise, start at step 10.
• SawStop T-Glide Fence System - 36” Replacement Rails for In-Line
Router Table (No Tube), Part Number: RT-TGP2-L-R36A
• SawStop T-Glide Fence System - 36” Rails Assembly for In-Line
Router Table, Part Number: TGP2-R36A2
If your rails are not installed on your
saw, install them now according to the
instructions in your table saw fence
manual, but
do not fully tighten the
hardware
. If your rails are already
installed, use a 5mm hex wrench and a
13mm wrench to loosen the hardware
securing your rear rail to your table
saw. See your table saw fence manual
for further information. Copies of your
manuals can be downloaded at
www.sawstop.com
. SawStop
recommends removing the main tube
and loosening the hardware securing
your front rail to your table saw.
In-Line Right: Between PCS 36” Rails
Requires:
“Wing Mounting Hardware” Bag for Power Switch for In-Line Router Tables
“Rail Mounting Hardware” Bag from Power Switch for In-Line Router Tables
Assembled Router Table with Support Legs
Straight
Edge
13mm Wrench (x2)
5mm Hex Wrench
Sold Separately: Intermediate Cast Iron Wing and Accompanying Hardware
Sold Separately: 36” RT-Ready TGP2 SawStop rails. Refer to the figures
on the previous page for reference:
THIS PROCEDURE REQUIRES TWO PEOPLE. THE ROUTER TABLE AND
OPTIONAL INTERMEDIATE CAST IRON WING ARE HEAVY AND CAN CAUSE
SERIOUS PERSONAL INJURY OR DAMAGE IF DROPPED.
