12
RT-TGP/RT-BT OWNER’S MANUAL
NEXT: INSTALL THE ROUTER TABLE on either the Benchtop Stand or in-line.
See page 2 for details.
4
Finger tighten the hex nuts up against
the bottom of the table. You will adjust
the screws and fully tighten the hex nuts
later, after you install your router lift.
•
•
•
For mounting to the Benchtop Stand, proceed to the next page.
For mounting to the left extension wing of your Professional Cabinet Saw
or Contractor Saw, proceed to page 19.
For right mounting between the rails of your Professional Cabinet Saw,
proceed to page 19.
Never place fingers,
toes or other body parts
under the mobile base.
!
WARN
ING
5
If you plan on installing the router table
in-line on your SawStop Professional
Cabinet Saw and you have the ICS
Mobile Base with PCS Conversion Kit
already installed on your saw, ensure
that the hold-down straps on the mobile
base have been secured to the saw
cabinet (these hold-down straps were
included with your ICS Mobile Base
with PCS Conversion Kit). If you did
not install them and no longer have
access to these straps, please contact
our Service Department for assistance:
[email protected] or 503-582-9934.
The router table is only compatible with the SawStop Contractor Saw
if cast iron wings are installed. The standard stamped wings on the
Contractor Saw cannot support the weight of the router table.
i
stamped
wing
