32
Setting a Stack of Originals in the Document Feeder
You can insert a stack of originals into the document feeder. These originals are individually fed onto and
removed from the exposure glass (platen glass).
Note
❐
Some originals are unsuitable for the document feeder.
☛
See page 30.
❐
Do not press down or hold originals after inserting them.
❐
While originals are fed from the original table to the exposure glass (platen glass), do not pull them out.
❐
Do not lift the document feeder until the original has been completely fed out.
1
Correct any curl, fold, or crease in the originals
before setting the originals.
2
Make sure the Insert Original indicator is lit and
the exposure glass (platen glass) is clear of origi-
nals.
3
Adjust the guide to the original size.
4
Set the originals
face up
into the document
feeder until the Insert Original indicator goes
off.
Note
❐
The last page should be on the bottom.
❐
The original guide must touch the front side of the
originals.
❐
Do not stack originals above the limit mark.
Setting a Stack of Originals in the Document Feeder
TRSR050E
1: Limit mark
2: Original guide
2
1
Summary of Contents for CS210
