7 of 35
Savant IP Audio Deployment Guide
009-1571-02 | 190508
Copyright © 2019 Savant Systems, LLC
3.3 PAV-SIPA50SM
Front Panel
Power LED
Green
: System has power and is operating normally.
Red
: System is in standby mode. In standby mode, most of the controller
circuitry is powered down.
Off
: System is not receiving power.
Status LED
Green Blinking:
Embedded system is ready, but no communication has been established with the host.
Green:
Host has established communications with the embedded system.
Red Blinking:
Embedded firmware is running, but has not received a DHCP IP Address.
Red:
Host has determined the firmware needs to be updated, but a problem occurred during the process that will initiate a reset.
Amber Blinking:
Embedded system has a valid link-local IP Address and is connecting to the host.
Amber:
Host is updating the embedded firmware.
Off:
Embedded processor is resetting, or is powered up, and is booting the embedded firmware.
Hardware Failure:
If a hardware failure occurs, the status LED indication will be interrupted every three seconds with a solid red
indication. For example, if the LED is blinking green when a hardware failure occurs, the LED will alternate between blinking green
and solid red at three-second intervals.
RS-232 LED
Green
: RS-232 serial port activity.
Off
: No RS-232 serial port activity.
IR LED
Green
: IR port signal activity.
Off
: No IR port activity.
On/Off button
On:
Fully enables all internal power rails and processor.
Off:
Disables most internal power rails and processor, but not internal AC/DC power supply.
Hold On/Off button for about 5 seconds to place into standby mode. The Power LED turns red.
Hold On/Off button for about 1 second to take system out of standby mode. The I/O power switch on the back of unit must be On
(I) to enable this function. To turn the power off for the entire system, press the I/O power switch on the rear panel to Off (O).
Reset button
Resets the network.
Hold Reset Button for 5 seconds while powered On to clear network settings. Status LED will blink Red rapidly when reset is
complete.
Zone Protection
Red
: Protection mode has been enabled to protect a zone / channel; Typically indicates thermal protection, clipping or over current.
Off
: Protection mode has not been enabled.
