32 of 35
Savant IP Audio Deployment Guide
009-1571-02 | 190508
Copyright © 2019 Savant Systems, LLC
Appendix B: Retrieving and Setting IP Address
The SDE must be connected to the same network/subnet as the Savant system in order for the devices to appear in rpmEmbSnanner. With Savant
Application Manager active, follow the steps below to check or set the device IP address:
NOTE
: The UID is needed to verify that the correct IP Address is being checked. Record the UID from the sticker located on the rear of the unit.
1.
Activate da Vinci 8.2 or higher.
2.
Go to
Launch > rpmEmbScanner
3.
Select the device to edit in the list, and click Edit
4. Click the Configure drop-down, Select Manually
5.
Enter IP Address (subnet mask and router will populate automatically).
6. Click
Save & Reboot
