6 of 35
Savant IP Audio Deployment Guide
009-1571-02 | 190508
Copyright © 2019 Savant Systems, LLC
3. Savant IP Audio Equipment Overview
3.1 Box Contents and Specifications
For full Box Contents, Specifications, and detailed physical product installation information for each Savant IP Audio product listed in the subsections
below, refer to the relevant Quick Reference Guide for the component SKU, available on the
Savant Customer Community.
3.2 PAV-SIPA1SM
Reset
Using a paperclip or similar, press and hold for 5 seconds to clear
statically assigned IP address, restart unit, and pull IP from DHCP.
If no statically assigned IP, this button does nothing.
Power LED
Green
: Unit has power, operating normally.
Red
: Unit in standby mode, most circuitry is powered down.
Off
: Unit not receiving power.
Status LED
Off
: Embedded processor resetting or booting firmware.
Green
: Communication with Host established.
Blinking Green
: System ready but no communication with Host.
Red
: Firmware update failure, unit will reset.
Red Blinking
: Firmware is running but has not received a DHCP IP
address.
Amber
: Firmware update in progress.
Amber Blinking
: Valid link-local IP address.
Hardware Failure
: If hardware failure detected, red blink will
interrupt any other LED status state at 3-second intervals.
Speaker Output
Single zone speaker output. Uses included 4-pin connector. Supports 8 ohm or 4 ohm speakers.
Analog Audio Output
2-channel preamp analog stereo output (Left and Right) Direct line-level 2.1V output
Analog Audio Input
2-channel analog stereo input (Left and Right) RCA line-level input 2.1 VRMS in; 22k ohms input impedance.
Digital Audio Input
Digital optical audio (TOSLink) input. Supports up to 192kHz/24-bit digital audio in; PCM stereo format only.
IR Control Ports
(3x) IR control ports. Uses 6-pin IR connector to send IR control signal to devices with IR input or via IR flasher (5V
tolerant only). See IR Wiring section below for important precautions before making connections.
Serial Control Ports
(2x) 3-pin serial ports used to transmit and receive serial binary data to/from serial controllable devices. Uses included
6-pin connector. See Serial Connections section below for pin-out information. CTS/RTS handshaking NOT supported.
Ethernet Port
8-pin RJ-45 auto-negotiating network connection port. Supports Audio Video Bridging (AVB).
Activity LED
- green blinking: activity (Tx/Rx), off: no activity.
Link LED
– green solid: link established, off: no link established.
Input Power
100/240V AC (50/60 Hz) 3.6A maximum.
Fuse
: 250V 5A fast-acting fuse; field replaceable.
