EMC 6/4, 6/4M, 6/4MT, EMC 10/4, EMC 10/4T:
Use alcohol or an electronic cleaner that dries or evaporates without leaving a film or
residue. Apply the cleaning fluid to a soft cloth and wipe the full length of both left
and right side Y-rails. Push the pantograph back and forth several times, then wipe
the Y-rails again. Repeat a third time if necessary.
NOTE:
Never spray an electrical cleaner direct onto the Y-rails. If the cleaner
contacts the peripheral chassis or covers, it may cause damage to
the composite materials.
The right,
rear Y-rail.
The right,
front Y-rail.
The right end of the
pantograph with the
table top removed.
Figure 1-6
1-8
Exterior Surfaces
Basic Maintenance
Melco Embroidery Systems
