SATEL INT-KWRL
5
the program and the control panel, you must start the service mode “from pins” – refer to the
control panel programming manual).
3.1.1 DLOADX program
You can add wireless keypad in the “Structure” window, “Hardware” tab, after clicking on the
name of ABAX system controller on the list of devices, and then on the “INT-KWRL” tab (see
Fig. 4 p. 7).
1. Click on the “Read” button to read the data related to wireless keypads from the controller
(these data are not read after clicking on the
button in the main menu).
2. Click on the “New device” button.
3. The “New device” window will open.
4. In the “Serial number” field enter the serial number of the added keypad. The sticker with
serial number you will find on the electronics board.
5. In the “Address” field, select which address is to be assigned to the keypad to be added.
6. Press any key on the keypad
7. The message will confirm that a keypad has been added (unless you have entered an
invalid serial number, of which you will be informed by a message). The name assigned to
the keypad will be displayed. You can change it.
8. Click “OK” (to cancel adding the keypad, click on the “Quit” button).
9. The “New device” window will close.
10. The new keypad will appear in the table in “INT-KWRL” tab.
11. Click on the “Keypads identification” button (the new keypad must be identified by the
control panel).
3.1.2 LCD keypad
You can add wireless keypad in the service mode by means of the N
EW DEVICE
function
(
S
TRUCTURE
HARDWARE
E
XPANDERS
SETTINGS
[controller name]
N
EW DEVICE
).
1. Having started the function, enter the serial number of the added keypad. The sticker with
serial number you will find on the electronics board.
2. Press
.
3. When the “Open device tamper” message is displayed, press any key on the keypad.
4. Information on the added keypad will be displayed (if nothing happens, it can mean that
you have entered an invalid serial number – if this is the case, press
to return to
the submenu).
5. Press
.
6. Use the
and
keys to select address for the keypad being added.
7. Press
.
8. Identification function will start automatically (the new keypad must be identified by the
control panel).
3.2 Removing the keypad from the wireless system
3.2.1 DLOADX program
You can remove the wireless keypads in the “Structure” window, “Hardware” tab, after
clicking on the name of ABAX system controller on the list of devices, and then on the “INT-
KWRL” tab (see Fig. 4 p. 7).