SATEL INT-KWRL
11
Volume/filter
Fig. 6. DLOADX
program: keypad settings stored in the control panel – “Volume/filter” tab.
Volume
– volume level of the beeps generated during keypad operation (key pressing,
confirmation of performed operation, etc.).
Volume – chime
– volume level of the beeps generated after zone violation (CHIME).
Volume – entry delay
– volume level of the entry delay beeps.
Volume – exit delay
– volume level of the exit delay beeps.
Volume – fire
– volume level of the fire alarm beeps.
Volume – alarm
– volume level when signaling burglar, panic and medical alarms.
Card reader filter
[Sensitivity] – the level of signal filtering by the proximity card reader
(when programming from the keypad: 1 – minimal filtering, 10 – maximal filtering). Higher
filtering level is useful where noise occurs, causing the reader to malfunction.
State inspections
Key hold-down
Some functions can be run by the users without having to enter the code.
1 – zone state
[Zones] – if this option is enabled, the user can inspect the zone state after
pressing and holding for 3 seconds the
key.
4 – partitions armed
[Partitions] – if this option is enabled, the user can inspect the partition
state after pressing and holding for 3 seconds the
key.
5 – alarm events memory
[Alarms log] – if this option is enabled, the user can view the
alarms log after pressing and holding for 3 seconds the
key.
6 – trouble memory
[Troubles log] – if this option is enabled, the user can view the troubles
log after pressing and holding for 3 seconds the
key.
7 – trouble status
[Troubles] – if this option is enabled, the user can view the current
troubles after pressing and holding for 3 seconds the
key.