SATA SATAjet 4000 B, Operating Instructions Manual

Page: 105 / 426

105
EN
Operating instructions SATAjet 4000 B RP/HVLP Operating instructions SATAjet 4000 B RP/HVLP
inaccurate method): rule of thumb: pressure at the pressure re-
ducer must be set 0.6 bar higher than the recommended spray gun
inlet pressure per every 10 m of air hose (inner width 9 mm).
7.2. Adjustment of the Material Flow
[4-1], [4-2], [4-3]
und [4-4] - material flow control fully opened
Notice!
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica -
tion speed.
7.3. Adjustment of the Spray Fan Pattern
• Adjust flat fan (factory setting) [5-1] .
• Adjust round fan [5-2] .
7.4. Painting
Fully pull trigger for painting [6-1] . Operate spray gun according to [6-2] .
Maintain spray distance as described in chapter 2.
8. Cleaning of the Spray Gun
Warning! Attention!
• Prior to cleaning, please disconnect the spray gun from the compressed air
circuit!
• Risk of injury due to unexpected leakage of compressed air or mate-
rial!
• Empty spray gun and gravity flow cup completely, dispose of paint
material appropriately!
• Disassemble and install components very carefully! Exclusively use
included special tools!
• Use neutral cleaning solution (pH value 6 to 8)!*
• Do not use acids, lyes, bases, pickling agents, unsuitable
regenerates or other aggressive cleaning solutions!*