Sartorius CH3E, Operating Instructions Manual

Page: 10 / 96

Connecting a Bar Code Scanner (Accessory YBR02CISL)
!
Disconnect the equipment from AC power (unplug the AC adapter)
§
Installation
For model CW3P:
– Connect a 25-pin D-Sub male connector to the COM 2 (UniCOM) port
– To connect both a bar code scanner and an external rechargeable battery, please use the YTC01 T-connector.
For model CW3S: please see “Pin Assignment Charts” in this manual (implemented via the YCC02-BR02 connecting cable or as Option M8)
Installing the Verification Adapter for Use in Legal Metrology (on verifiable models only)
§
Remove the nut located on the back of the indicator
§
Use the slotted screw to install the adapter plate
§
Affix the verification seal over the adapter
10
Operating Tolerances
Never exceed the maximum capacity of the weighing platform.
The maximum loading capacities of the weighing platforms are listed
in the table below, and depend on the position of the load on the platform:
Platform size Center Side Corner
320 + 240 50 35 20
400 + 300 130 85 45
500 + 400 300 200 100
500 + 400 (P*) 600 400 200
650 + 500 (S**) 450 300 150
800
+
600 (P*) 1200 800 400
800
+
600 (S**) 900 600 300
800 + 800 4500 3000 1500
1000 + 800 4500 3000 1500
1000 + 1000 4500 3000 1500
1250 + 1000 4500 3000 1500
1500 + 1250 4500 3000 1500
1500 + 1500 4500 3000 1500
2000 + 1500 4500 3000 1500
* Steel
** Stainless Steel