16
1.
Align
E
and
I
(upper mounting tubes) directly above
lower stall. The high mount (I) and low mount (E)
must correspond with the high and low mounted
lower stalls. The first mounting tube bracket should
be flush to the end of the upper cross beam.
2.
Space and stagger upper mounting tubes on the
upper cross beam per figure 2.
3.
Install
L
(backing brackets) using
Q
(M10x25mm
carriage bolts) with
W
(washers) and
S
(M10
locknuts). Tighten to 30 ft/lbs (41 Nm).
1. Align
E
and
I
(upper mounting tubes) directly above lower stall. The
high mount (
I
) and low mount (
E
) must correspond with the high and
low mounted lower stalls. The fi rst mounting tube bracket should be
fl ush to the end of the upper cross beam.
2. Space and stagger upper mounting tubes on the upper cross beam
per fi gure 2.
3. Install
L
(backing brackets) using
Q
(M10x25mm carriage bolts)
with
W
(washers) and
S
(M10 locknuts). Tighten to 30 ft/lbs (41 Nm).
Roller Beam Installation
