Sargent EC600 Handbook Download Page 4

Page: 4 / 20

1 Template

Instructions

<<Delete before
use>>

EC600 Power Control System

Issue 2.3

Page 4 of 20

August 2017

Tree

Leisure battery

, the leisure battery voltage and charging or discharging current is

displayed. Use the select button to toggle the display, with voltage on the main
display whilst current (in or out of the battery is shown on the bar-graph and vice
versa, current on the main display and voltage on the bar-graph.

Vehicle battery,

when connected the vehicle battery voltage and charging or

discharging current is displayed. Use the select button to toggle the display, with
voltage on the main display whilst current (in or out of the battery is shown on the
bar-graph and vice-versa, current on the main display and voltage on the bar-graph.

Solar Power,

the charging current from the solar panel along with the voltage of the

battery it is charging is displayed. Use the select button to toggle the display, with
voltage on the main display whilst current is shown on the bar-graph and vice-versa,
current on the main display and voltage on the bar-graph.

Select Battery,

press the select button toggles between the Leisure and Vehicle

batteries as the power source (or battery to be charged). The selected battery is
shown in the header area.

Tank-Fill on/off,

(Caravan Only) Turn tank fill on to start the external water pump

and to start transferring water from the external water container to the internal water
tank. Tank filling will stop when the onboard tank is full or if more than 7 minutes
have elapsed.

Tank Heaters on/off,

(Motorhome Only) this feature enables or disables the

automatic Fresh & Waste water tank frost protection system. Tank heating will start
when the tank level is 25% or higher and the external temperature is under 2 degrees
C.

AC Limit,

the AC current limiter, when enabled, will monitor the incoming AC current

and if the set limit is reached the 230V heating element within the heating system will
be temporarily turned off until the current falls below the set limit. Use the select
button to set the limit or to turn the feature off. The AC Limit icon in the header
indicated that a limit is set and will flash if the limiter is active. For this feature to
work correctly the Heating setting must be set to Timer so that the EC600 system
can control the heating system.

Temperature & Humidity,

Pressing the select button scrolls through the internal

temperature, internal humidity & external temperature readings. Please note that due
to the location of the internal temperature sensor there may be slight differences to
the temperature shown on the heating system. Further details can be found in
section 3.18.

Dimmer %,

this display shows the lighting dimming level and is adjusted in 5%

increments. The display commences where the level was last set. Press the select
button to increase the level up to 100% and then back down again to 5%. Pressing
the dimming button on the control panel immediately shows this dimming value.

Heater Settings,

this sub menu

allow the heater controls and associated settings to

be adjusted. A full explanation of the controls can be found in the heater section.

Air Conditioning Settings,

this sub menu

allow the optional air-conditioning controls

and associated settings to be adjusted. A full explanation of the controls can be
found in the aircon section.

Fridge Settings,

this sub menu

allow the fridge controls and associated settings to

be adjusted. A full explanation of the controls can be found in the fridge section.