Page:20
3
.
16
—
Command 43: Identify Lock Mechanics
Use command 43 to verify the firmware version loaded into the lock.
Step 1
Enter: 4 3 *
Step 2
Listen for the beeps to determine the lock mechanics.
The lock will emit one low beep, one high beep, and one low beep to begin the sequence. The next set of beeps
will indicate the type of lock mechanics being used. The lock mechanics will also be shown on the display.
1 beep = PIVOT BOLT
2 beeps = DIRECT DRIVE
3 beeps = MOTOR DRIVE
4 beeps = MOTOR GEAR
Lock Type
Pivot Bolt
Lock Type
Motor Drive
Lock Type
Direct Drive
Lock Type
Motor Gear
3
.
17
—
Command 44: Identify Operating Mode (Bank Mode)
Use command 44 to verify the firmware version loaded into the lock.
Step 1
Enter: 4 4 *
Step 2
Listen for the beeps to determine the operating mode.
The lock will emit one low beep, one high beep, and one low beep to begin the sequence. The next set of beeps
will indicate the operating mode.
2 beeps = Manager/employee mode
3 beeps = Dual control mode
4 beeps = Multiple user mode
3
.18
—
Command 45: Initializing the Lock
Multiple
User Mode
Dual
User Mode
Manager/Employee
User Mode
The lock can be initialized into Service Mode using command 45 and a properly programmed management touch key.
Please see Section 4.1
–
Initializing the Lock for more information on initializing the lock.
3
.
19
—
Command 46: Setting Up the Time Delay Override Options
When the time delay feature is enabled, the A-Series with Display
TM
Lock can be programmed with a time delay override
(TDO) feature that will allow a specific user to bypass the time delay countdown. The time delay override code must
always be setup in PIN position 29.
There are two types of TDO available. TDO TYPE 1 requires that the time delay override code is entered within the first
minute of the time delay countdown. In other words, a User must start the time delay countdown by entering their
code. If the time delay override code is entered within the first minute, then the lock will open.
TDO TYPE 2 will allow the lock to be opened by the time delay override code without requiring another User start the
time delay countdown.
