Page:13
3
.
8
—
Command 12: Set Time
You must set the time to use Service Mode and audit trail functions. The time should be set in HHmm format based
on a 24-hour clock, where HH = hours and mm = minutes. The time should be set before initializing the lock. The
time is to always be set in local standard time. Local standard time must be set, even though Daylight Savings Time
may be in effect. To set the time, perform the following steps:
Step 1
Enter: 1 2 *
Step 2
Enter: 8-digit Programmer PIN Code (00) #
♪♪♪♪♪
Step 3
Enter: Time in HHmm format #
♪♪♪
Step 4
Enter: Time in HHmm format #
♪♪♪
Set Time
Enter Code
********
Enter Time
HH:MM
**:**
Confirm Time
HH:MM
**:**
Example
To set the time as 1:42 PM, use 13:42 (using the factory default Codes):
Step 1
Enter: 1 2 *
Step 2
Enter: 0 0 1 2 3 4 5 6 #
♪♪♪♪♪
Step 3
Enter: 1 3 4 2 #
♪♪♪
Step 4
Enter: 1 3 4 2 #
♪♪♪
Set Time
Enter Code
********
Enter Time
HH:MM
13:42
Confirm Time
HH:MM
13:42
The time & date must be set and the clock started (13*)
before the settings are saved by the lock.
3
.
9
—
Command 13: Start the Clock
After setting the time and date values, you must use a separate command to start the clock. This step helps to match the
time in the lock to your current time. To start the clock, perform the following steps (after programming time & date):
Step 1
Enter: 1 3 *
Step 2
Enter: 8-digit Programmer PIN Code (00) #
♪♪♪♪♪
Step 3
Enter: sequence to start the clock 1#
♪♪♪
Step 4
Enter: sequence to start the clock 1#
♪♪♪
Start Clock
Enter Code
********
Enter 1
To Start Clock
Enter 1
to Confirm
