Sapido Gr-1100, User Manual

Page: 219 / 294

219
This value should remain at its default setting of 2346. The range is 256-2346 byetes. It
specifies the maximum size for a packet before data is fragmented into multiple packets.
If you experience a high packet error rate, you may slightly increase the Fragmentation.
Setting the Fragmentation tool low may result in poor network performance. Only minor
modifications of this value are recommended.
4. SSID
Wireless network name, it is selected AP name in Quick Setup.
5. bg Mode
This field indicates the 802.11g interface mode. “802.11g” prevents the 802.11b clients
from accessing the router. “bg Mixed” allows both 802.11b and 802.11g clients to
access the router. “802.11b” will enable the network as an 802.11b wireless network. By
default, the Mode is “ bg Mixed ”.
6. Rate
Select the transmission rate for the network. The default setting is “ Auto ”.
7. Channel
IEEE 802.11g and 802.11b devices are direct sequence spread spectrum devices that
spread a radio signal over a range of frequencies. The range of frequencies used by a
direct sequence device is called Channel.
The 802.11g and 802.11b specification supports up to 14 overlapping Channels for
radio communication. To minimize interference, configure each GR-1100 to use
Non-overlapping channels. Non-overlapping channels have 25 MHz separation
beginning at the first allowed channel for the country (for the US and most of Europe,
channel 1,6 & 11 are used.).
8. Specify an IP
Input the IP address, Subnet Mask, Gateway and DNS.