89
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If
this equipment does cause harmful interference to radio or television reception, which can
the interference by one or more of the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
l
Consult the dealer or an experienced radio/TV technician for help.
Cautions
Any changes or modifications to your phone not expressly approved in this document could
void your warranty for this equipment and void your authority to operate this equipment.
Only use approved batteries, antennas and chargers. The use of any unauthorized
accessories may be dangerous and voids the phone warranty if said accessories cause
damage or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and can be broken.
Avoid dropping, hitting, bending or sitting on it.
Body-Worn Operation
To maintain compliance with FCC RF exposure requirements, Body-worn operations are
restricted to belt-clips, holsters or similar accessories that have no metallic component in
the assembly and that provide at least 1.8 cm separation between the device, including its
antenna whether extended or retracted, and the user’s body. The use of accessories that do
not satisfy these requirements may not comply with FCC RF exposure requirements. For
more information about RF exposure, please visit the FCC website at www.fcc.gov.
Specific Absorption Rate (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy absorbed in the
head of a user of a wireless handset. The SAR value of a phone is the result of an extensive
testing, measuring and calculation process. It does not represent how much RF the phone
emits. All phone models are tested at their highest value in strict laboratory settings. But
when in operation, the SAR of a phone can be substantially less that the level reported to the
FCC. This is because of a variety of factors including its proximity to a base station antenna,
phone design and other factors. What is important to remember is that each phone meets
