Sanyo POA-MD13NET2, Owner'S Manual

Page: 150 / 176

62
Chapter 6 Use of Serial Port
Use of Telnet
You can control the equipment connected to the serial port on the network board and
control projector itself by using the telnet application*
1
installed on your computer.
The following is a control example of external equipment. The telnet application is
required to use commands*
2
which control the external equipment.
Preparation
1
Turn the projector off with the mains switch and connect an external equipment to
the serial port with an RS-232C serial cable.
2
Turn the projector and external equipment on.
3
Display the setting page by clicking on the Serial Port linked text on the main menu
with the web browser. (
☞
p.58)
4
Change the serial port setting to be the same communication condition as the con-
nected external equipment and then press the
Set button.
The following example setting is for our projector
communication condition. When controlling our pro-
jector set as follows
:
Control
(For example, in case of using the Telnet application in the Windows 98.)
1
Select the Run... submenu from the Start menu on the computer. Type “telnet” onto the
Open text area on the displayed window and press the OK button.
2
Launch the telnet application and the following window will be displayed. Select
the
Remote System from the Connect pulldown menu.
*1 For further instructions about the telnet application, please see the on-line guide on your
computer. Macintosh does not provide the telnet application.
*2 The commands are defined by each product independently, so please consult the manufac-
turer or sales dealer for further information of the commands.
Baud rate ..........19200
Parity ................NONE
Stop ..................1
Flow Control ......NONE
Data ..................8
Serial Control ....External
Port ..................23