PLC-ET30L Expand Serial Command Functional Specifications
32/62
8.10.4 CF_CEIL Command
Command
“CF_CEIL_%1” [CR]
%1
“ON” --------------------------- Set Ceiling to ON.
“OFF” ------------------------- Set Ceiling to OFF.
Details
Set/Cancel Ceiling mode.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.10.5 CF_REAR Command
Command “CF_REAR_%1” [CR]
%1
“ON” --------------------------- Set Rear to ON.
“OFF” ------------------------- Setl Rear to OFF.
Details
Set/Cancel Rear mode (Available only in the normal Power ON status)
When Rear is ON, projected image is left/right reversed.
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.10.6 CF_RCODE Command
Command
“CF_RCODE_%1” [CR]
%1
“001” ------------------------------------ Select Code 1
“002” ------------------------------------ Select Code 2
“003” ------------------------------------ Select Code 3
“004” ------------------------------------ Select Code 4
“005” ------------------------------------ Select Code 5
“006” ------------------------------------ Select Code 6
“007” ------------------------------------ Select Code 7
“008” ------------------------------------ Select Code 8
“UP” ---------- Switch forward (Code1
→
Code2
→
Code3 - - -
→
Code8
→
Code1)
“DN” --------- Switch backward (Code8
→
Code7
→
Code6 - - -
→
Code1
→
Code8)
Details
Select Code of Remote Control (Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.10.7 CF_RCSENSOR Command
Command
“CF_RSENS_%1” [CR]
%1
“BOTH” -------------------------------- Select both front and back receiver of projector
“FRONT” ---------------------------- Select only front receiver of projector
“BACK” ------------------------------------ Select only back receiver of projector
“UP” --------- Switch forward (BOTH
→
FRONT
→
BACK
→
BOTH)
“DN” --------- Switch backward (BACK
→
FRONT
→
BOTH
→
BACK)
Details
Select location of infrared remote receiver of remote control (Available only in the
normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
