PDG-DXL2000 Expand Serial Command Functional Specifications
30/72
8.7.8 CF_HPOS Command
Command “CF_HPOS_%1”[CR]
%1
“015” --------- +15
“014” --------- +14
：
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
：
“-14” ---------- -14
“-15” ---------- -15
“UP” ---------- Horizontal Position setting value + 1
“DN” ---------- Horizontal Position setting value - 1
Details
Set Horizontal Position
This command is available in normal Power ON status.
Note1) Screen mode is changed into Custom by receiving this command.
Note2) When there is no Input, projector returns 101 and the command does not
execute.
Acceptable
“000”[CR]
Response
Unacceptable “Error Code”[CR]
8.7.9 CF_CEIL Command
Command “CF_CEIL_%1”[CR]
%1
“ON” ------------------------ Set Ceiling to ON
“OFF” ----------------------- Set Ceiling to OFF
Details
Set/Cancel Ceiling setting.
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
Acceptable
“000”[CR]
Response
Unacceptable “Error Code”[CR]
8.7.10 CF_REAR Command
Command “CF_REAR_%1”[CR]
%1
“ON” --------------------------- Set Rear to ON
“OFF” ------------------------- Set Rear to OFF
Details
Set/Cancel Rear setting.
When Rear is ON, image is left/right reversed.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
“000”[CR]
Response
Unacceptable “Error Code”[CR]
