Sanyo LED-46XR123D, Instruction Manual

Page: 7 / 37

Identification of Controls
Main Unit (front/side view)
1. Remote sensor
2. Power indicator
Lights red when in standby mode.
Flashes red during booting, then goes out when in normal working mode.
3. 3D emitter
Transmits 3D SYNC signals (infrared).
Note: If there is any obstacle between the emitter and 3D Glasses,
the proper 3D effect may not be obtained.
4. MENU
Press this button to access the main menu screen.
5. INPUT
To access Input Source menu.
6. VOL+
Press the VOL+ or VOL– button to directly increase or decrease
the sound volume level;
In menu operations, these buttons serve as right/left buttons.
7. CH
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
8. POWER
Receives signals from the remote control. Do not block.
/–
^
/
^
Press this button to turn the unit ON from STANDBY mode. Press it
again to turn the set back to STANDBY.
Main Unit (back view)
1. S/PDIF digital audio output: Connect a digital sound
system to this jack.
2. USB port: Connect a USB device to this port.
3. HDMI3: Connect an HDMI device to this jack.
4. Headphone: Connect headphones to this jack.
5. AV INPUT: Connect an AV device to these jacks.
6. RS-232: For service only. Do not use.
7. HDMI1
(with ARC)
: Connect an HDMI device to this jack.
8. HDMI2: Connect an HDMI device to this jack.
9. MUSIC: Connect a MP3 player to this jack.
10. PC IN D-SUB/AUDIO: Connect a computer to these
jacks.
11. COMPONENT IN: Connect a component video device
to these jacks.
12. RF: Connect an antenna to this jack.
7
1
2
3
4
5
6 7 8 10 12
MUSIC/AUDIO D-Sub P
B
P
R
Y L R
COMPONENT IN
AUDIO
RS-232 HDMI 1 HDMI 2 PC IN RF
9 11
A
V
I
N
V
ID
E
O
A
U
D
IO
L
R
H
D
M
I
3
U
S
B
S
/P
D
IF
ARC
1 2
3
INPUT
MENU
VOL
CH
4
5
6
7
8