Sanwa CD770, Instruction Manual

Page: 39 / 56

— 8 —
[5] MEASURING PROCEDURE
5-1 Start-up Inspection
1. Do not apply an input signal exceeding the maximum rated
input of each function.
2. During measurement, do not change the function switch.
3. During measurement, do not touch the test pin side of the
flange of the test lead.
4. When measurement has been finished, remove the test pins
from the object measured and return the function switch to the
OFF position.
WARNING
1. Be sure that the battery low warning mark is not flickering or lit, when
the meter is turned on. If it is flickering or lit, replace the batteries with
new ones.
2. Do not use the meter if the meter or test lead is damaged or broken.
3. Make sure the test leads are not cut and the fuse has not blown.
CAUTION