11
Instruction Manual for IL COIL CLEAN & ITS VARIOUS MODELS
1-888-726-8869
www.sanuvox.com
How to Clean your Product
For optimal performance, the lamp(s) should be kept free of dust and residue deposit. Clean when necessary with mild soap or
alcohol. To clean the unit exterior, use a damp cloth with general purpose detergent. Always spot test the cleaner to make sure
it does not damage the surface.
CAUTION: Under no circumstance should water be sprayed or splashed onto the product.
STORAGE
The IL Coil Clean and its various models does not require specific storage. It is a permanent unit that works continuously when
powered.
CAUTION: Keep away from unsupervised children. This unit is not a toy.
ULTRAVIOLETS: UVC
The UVC (254 nm) wavelengths produced by Sanuvox UV units and systems are the same as the ultraviolets produced by the
Sun. The UVC attacks the micro-organisms on a molecular level deactivating the contaminants. Unlike conventional UV lamps
on the market, Sanuvox UV units and systems use a patented process designed to deliver the maximum UV dosage to the
moving airstream or surface.
CAUTION: Never expose eyes or skin to an operating UV lamp.
ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE
The IL Coil Clean and its various models has a power consumption that varies according to its lamp length: 1.0 amps for 40"
lamps, 1.25 amps for 50" lamps and 1.5 amps for 60" lamps.
See product label to confirm power consumption of your specific unit or system.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CUSTOMER SERVICE FIRST OR SEE YOUR WARRANTY.
DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE
PRODUCT OR TAMPER WITH ITS COMPONENTS WITHOUT CONTACTING CUSTOMER SERVICE FIRST. DOING SO
MAY VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.
Problem
Possible Cause
Solution
LED on ballast box is YELLOW.
- The UV lamp needs replacement.
- Replace UV lamp.
LED on ballast box is FLASHING RED.
- The UV lamp has failed or the unit
is powered ON without any UV lamp
installed.
- Make sure there is a UV lamp installed
in the unit.
- Replace UV lamp.
LED on ballast box is OFF.
- There is no power delivered to the unit
or power supply is defective.
- Make sure there is power to the unit.
- Replace power supply.
Contact your contractor for all your needs in terms of replacement parts:
UV lamps, Anodized Aluminum Parabolic Reflector, Clamp Assembly, Lamp Boots, etc.
TROUBLESHOOTING
If your product is not working properly, refer to the following.
What you will need
A Phillips No. 2 screwdriver, a non-magnetic 5/16" nutdriver and spare parts.
