Sans Digital AccuSTOR AS424X12, Hardware Detailed User'S Manual

Page: 39 / 76

Appendix C. Command Line Interface
31
To ensure proper communications between them JBOD subsystem and the VT-
100 Terminal Emulation, please configure the VT100 terminal emulation settings
to the values shown below:
Terminal requirement
Connection Null-modem cable
Baud Rate
115,200
Data bits 8
Stop 1
Flow Control None
The JBOD Subsystem’s RJ-11 connector’s pin assignments are defined as
below:
RS-232C Pin Assignments
Pin Description Pin Description
1 N/C
6 NC
2 GND
3 RX
4 TX
5 CTS
By connecting a VT100 compatible terminal, or a PC operating in an equivalent
terminal emulation mode, all RAID subsystem monitoring, configuration and
administration functions can be exercised from the VT100 terminal.
There are a wide variety of Terminal Emulation packages, but for the most part
they should be very similar. The following setup procedure is an example Setup
of VT100 Terminal in Windows XP system using Hyper Terminal Version 5.1.
Step 1. From the Desktop open the Start menu. Pick All Programs, Accessories,
Communications and Hyper Terminal. Open Hyper Terminal (requires version 3.0
or higher)