SanRex SANARG 200AP, Operator'S Manual

Page: 26 / 90

26
•
The intelligent cooling system is designed to reduce dust and foreign material
build-up, while providing optimum cooling.
•
Fan speed reduces approximately 30 seconds after machine is turned on.
•
Fan speed increases when internal components reaches operating temperature.
ON/OFF Switch
•
Mains ON/OFF switch located on rear panel.
Voltage Reduction Device (VRD)
•
VRD fully complies with IEC 60974-1.
•
VRD light is ON and operational when in STICK mode.
Control Knob
•
For the selected weld parameter, rotating the knob clockwise increases the
parameter.
•
Rotating the knob counter-clockwise decreases the parameter.
•
A selected weld parameter value can be adjusted at any time even while welding.
•
Pressing the Control Knob while welding will display the arc voltage.
Self-Diagnostic Error Codes
•
An error code is displayed on the Digital Meter when a problem occurs with Mains
supply voltage or internal component problems.
High Frequency TIG Starting
•
Using the HF TIG function provides an easy non-touch Arc-Start.
•
Eliminates the possibility of the Tungsten Electrode to contaminate the base metal.
This non-touch Arc-Start is suitable for code welding regulation.
Save/Load of Welding Programs
A total number of 5 welding programs can be saved into the SanRex 200AP
memory.
SAVEing the Current Weld Parameters into Memory
•
Press the SAVE button.
•
Select one of the five (ie. 1 thru 5) memory location by rotating the control knob.
Numbers 1 thru 5 will be displayed on the meter as the control knob is turned.
After selecting the desired memory location (ie 1 to 5), press the parameter button, the machine
sound a beep to confirm the weld parameters from the control panel are saved.