8
Important
Ensure that the brass terminal is correctly inserted and that the fluorescent tube audibly engages.
4. Operation
Drying UV nail gel
1. Insert the mains plug into the socket.
2. Insert your nails varnished with UV nail gel into the opening in the device (with your nails facing upwards).
3. To set “Continuous operation”, set the selection switch to On. The UV light will light up continuously.
4. Switch the device off once you have finished using it. For this purpose, set the selection switch to Off and remove
the mains plug from the socket.
5. The majority of commercially available UV nail gels have a curing time of 120 seconds. For more information,
please observe the information from the corresponding nail gel manufacturer.
5. Maintenance and cleaning
Replacing the fluorescent tubes
If the UV fluorescent tube ceases to work properly, this must be replaced.
You can order the required fluorescent tubes from Customer Services.
Warning
Before replacing the fluorescent tubes, pull the mains plug out of the socket!
Important
Only insert a UV-9W-L type UV fluorescent tube into the device.
To replace the UV fluorescent tube, follow the steps contained in section “3. Initial use”.
Cleaning
Warning
Before beginning cleaning, pull the mains plug out of the socket!
• Clean the surface of the device carefully using a slightly damp cloth only.
• Do not use any cleaning agents or solvents.
6. What if there are problems?
Problem
Possible cause
Solution
Device will not switch on. Mains plug not plugged in.
Insert the mains plug into the socket.
No voltage at mains socket.
Check your fusebox.
UV nail gel does not dry.
Treatment time with UV light too short.
Set a longer UV light treatment time.
UV fluorescent tube does
not light up.
UV fluorescent tube not correctly in-
serted.
Check that the UV fluorescent tube has
been correctly inserted.
UV fluorescent tube faulty.
Insert a new UV fluorescent tube.
7. Replacement parts and wearing parts
Replacement parts and wearing parts are available from the corresponding service address (according to the service
address list). Please state the corresponding order number.
Designation
Item number and/or order number
UV fluorescent tube
163.655
8. Disposal
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment).
If you have any queries, please contact the appropriate local authorities.
