Sanitas SBG 58, Instructions For Use Manual

Page: 22 / 76

22
6 Installing the control unit
Wall mounting
Using the mounting kit, you can mount
the control unit on a wall. Use the mount-
ing kit provided and install the wall
holder as shown.
•
Drill 2 holes in the wall next to each
other horizontally, spaced 82 mm
apart. Using a 6 mm drill, drill holes in
the wall with a depth of approx. 40
mm. Insert the wall plugs.
•
Turn the fastening screws into the
wall plugs, until only about 4 mm of
the screw heads protrude.
•
Fasten the wall holder, then set the
control unit on the holder.
Alternative wall mounting method
You can also fasten the wall holder to a
wall using the double-sided adhesive
tape. For this purpose, the wall surface
must be clean and dry.
•
Remove the protective film from the
adhesive tape on the rear side of the
wall holder.
•
Press the wall holder firmly against
the wall.