V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230328
Diagnostics:
See inner door of vendor or Troubleshooting section for errors and how to clear them.
Coin Payout:
Allows you to payout coin tubes.
•
Press (2) to enter into “Coin Payout” mode.
•
Press (1) to choose denomination.
•
Press (2) to dispense displayed denomination.
•
Press (3) to exit mode.
Tube Fill:
Allows you to fill coin tubes via the external coin insert. This is the recommended way to fill the
coin tubes because the control board is able to keep an accurate count of the coins.
•
Press (2) to enter into “Tube Fill” mode.
•
Insert coins into coin insert slot and the controller will “count” the number of coins going
into the coin mechanism.
Test Mode:
Allows you to test vend a column, jog a column, test selection switches, display, refrigeration
system, lights, and heater.
Vend Testing:
•
At “Test Mode”, press (2)
•
Display will read column X
•
Press (1) to choose desired column
•
Press (2) to vend
o
If motor vends OK, DISPLAY will read “Test Mode - Vending Motor OK”
o
If motor does not test OK one of the following messages will appear:
“Test Mode - Vending Fail - Column Jam”
“Test Mode - Vending Fail - No Connection”
“Test Mode - Vending Fail - High Current”
Jogging a Column:
•
At “Test Mode” press (2)
•
At “Test Mode – Vending” press (1)
•
Display will read “Test Mode - Jog”
•
Press (2) and display will read “Column 1”
•
Press (1) to choose desired column
•
Press (2) to enter into column and display will read “Column X Forward” with X being the
desired column.
•
Press (1) to toggle between “Forward” or “Reverse”
•
Press (2) to move/jog the motor in the desired position
•
Press (3) to exit this mode
V21 12.3
Programming HVV | P4-3