8
S&C Instruction Sheet 461-509
Follow these steps to power up the communication gateway:
STEP 1.
Remove the red protection cap attached to the power-connection terminal at
the bottom of the communication gateway.
STEP 2.
Open the box.
STEP 3.
Run the ac power cable down the pole. The unterminated end of the cable
should be connected to the overhead transformer.
Figure 3. The Communication gateway control I/O (PSIO) Board.
STEP 4.
Align the fi ve-pin connector at the terminated end with the notch of the power
connection terminal, make the connection, and tighten the ring. See
Figure 2 on page 7.
STEP 5.
After a short delay, LEDs on the power supply/control I/O (PSIO) board and the
gateway controller should light up, indicating the communication gateway is
receiving power. See Figure 1 on page 6 and Figure 3.
Follow these steps to secure the communication gateway:
STEP 1.
Close the door and use the door latches to secure the enclosure. See Figure 2
on page 7.
STEP 2.
The door latches accept locks with a maximum shackle diameter of
⅜
-inches
(9.5 mm).
Powering Up the
Communication
Gateway
Securing the
Communication
Gateway
Mounting, Powering Up, and Securing the Communication Gateway
LED light
on I/O
board
