60
S&C Instruction Sheet 461-509
Confi guring the Communication Gateway
Command (Binary Output) Points Configuration
This field contains configuration parameters for command point mapping. See
Figure 54. Mapping these points will make them available in SCADA.
Status Point:
This is the point number the SCADA system will use when operating the
command point.
Code Description:
Binary outputs are used by the SCADA master to update settings in
the communication gateway or any of the associated TripSaver II reclosers. A full list of
code-description defi nitions is found in Instruction Sheet 461-560, “S&C TripSaver® II
Communication gateway:
DNP Points List and Implementation.
”
Figure 54. The Command (Binary Output) configuration field.
