S&C 5800 Series, Installation Manual

Page: 8 / 38

8 S&C Instruction Sheet 1042-511
Installation
Team Installation/Setup
Phase 2
Install and configure the repeater radio .
(See the documentation for your
communication equipment .)
Go to the installation location
of the next team member .
Start here after
completing Phase 1
Program all DNP radios
in the shop .
Make sure all radios communicate .
Go to the site of the
first team member .
Install the switch control hardware .
Install the communication hardware .
(installation instructions)
Start IntelliLink software and establish
communication between the team
member and your computer .
(setup instructions)
Use IntelliLink software to enter
all setup parameters, including the
“DNP/RTU Address .”
(setup instructions)
Is a
repeater
radio required
between this team
member and the
next?
If desired, save a snapshot .
(operating instructions)
On the faceplate,
enable Automatic Operation
and toggle SCADA Control to
the Remote setting .
Have you
already installed
and set up
all other team
controls?
Go to Phase 3
(see next page)
Figure 2. Suggested team installation and setup procedure, Phase 2.