S&C 5800 Series, Installation Manual

Page: 6 / 38

6 S&C Instruction Sheet 1042-511
Installation
Planning the
IntelliTeam II System
Suggested Team Setup
Procedure
The IntelliTeam II Automatic Restoration System enables teams of controls to work together
to isolate faults and restore service. Whether the team consists of a few switches on a single
feeder or a complex configuration with multiple alternate sources, mapping out the team(s) and
gathering all necessary information before installing hardware in the field is recommended.
Keep a copy of this information in the door of the switch control enclosure or low-voltage
cabinet.
During planning and setup of fault detection settings, be sure to consider the fault
conditions that the IntelliTeam II system may encounter from alternate sources. For more
information, see the “About Fault Detection, Switch Control Setup Point 6” in Instruction
Sheet 1042-531, S&C 5800 Series Automatic Switch Controls With IntelliTeam
® II Automatic
Restoration System: Setup .”
When configuring a switch control and team for normal operation, the installer will carry
out the series of steps, outlined in this section.
Make a copy of the flowcharts so they can be easily referred to when installing and setting
up the IntelliTeam II system.
The values entered on each setup screen depend on the electrical distribution system and
details specific to each individual switch.
Figure 1 on page 7, Figure 2 on page 8 and Figure 3 on page 9 show the normal procedure for
setting up an IntelliTeam II system, and this switch control.
NOTICE
These flowcharts assume the team consists entirely of S&C 5800 Series Switch
Controls . When the team includes other control types or IntelliRupter
®
PulseCloser
®
Fault Interrupters some of the steps may be slightly different .