Samsung SRP-350PG - SRP 350 B/W Direct Thermal..., Service Manual

Page: 27 / 125

3-1
3 Installation and Operation
3-1 Installation
3-1-1 AC Adapter Installation
Figure3-1 AC Adapter Installation
3-1-2 Interface Cable Installation
Figure3-2 I/F Cable Installation
3-1-3 Drawer Cable Installation
Figure3-3 Drawer Cable Installation
3-1-4 Paper Roll Installation
Figure3-4 Paper Roll Installation
2. Plug the DC cord connector into the power jack on
the printer. (Plug the flat side down)
3.Plug the AC Adapter power cord into the wall outlet.
1. Turn the printer off.
2. Plug the drawer kick-out cable connector into the
connector on the printer.
(To remove the drawer kick-out cable, press the clip
on the connector, grasp the connector and pull it out)
1. Make sure the printer is turned off with the 0 side of
the switch.
1. Turn off the printer, host ECR and Computer.
2. Plug RS-232,RS-485 or Paralled Cable connector.
into the I/F connector on the printer.
3. Tighten the screws on both sides of the connector.
4. Turn on the printer, host ECR and computer.
1. Open the cover printer and remove the used paper
rol core if there is one.
2. Load the paper roll on the paper holder as shown.
3. Close the cover printer.
Power Connector
AC Adapter
Drawer Kick-Out Cable
Drawer Kick-Out
Connector
Serial Interface Cable
Interface
Connector
Samsung Electro-M
e
chanics