setup screen
external ptZ setup
Configure the connection settings to the external pan/tilt receiver so that you can control
the PTZ operations via the receiver connected to the RS-485 port of the camera.
1.
Select the <
video & audio ( )
> tab
from Setup menu.
2.
Click <
external ptZ setup
>.
3.
Specify the serial port.
You can set the RS-485 communication
mode for pan/tilt-compliant receiver that
is connected to the network camera.
•
Protocol : From SAMSUNG-T/
SAMSUNG-E / PELCO-D/PELCO-P
/ SUNGJIN, select the same protocol
as that of the receiver.
•
Camera ID : Provide a camera ID.
•
Baudrate : Transfer rate for RS-485
communications.
•
Data bit : Specify the data bit.
•
Parity bit : Specify the parity bit.
•
Stop bit : Specify the stop bit.
4.
When done, click [
apply (
)
].
M
`
All these operations above mentioned will be enabled only if the network camera is properly
connected to the pan/tilt-compliant receiver. And the serial port for the pan/tilt operations should
be properly specified.
J
`
The baud rate may not be controlled depending on the product specifications.
5.
Adjust the direction.
•
[
change direction to ( )/( )/( )/( )/( )/( )/( )/( )
] : Change
the direction of camera lens.
•
[
moving speed control (
)
] : The bigger the number is, the faster the moving
speed becomes.
58_
setup screen
