Samsung SCX-82x0 series, Service Manual

Page: 320 / 399

7. Troubles
●
C d
●
E
●
Code :
M2-2213
M2-2215
M2-2216
●
Error message :
Paper jam at the top
●
Symptom / Cause :
Paper transport jam (paper Input section)
1. The paper has not reached the duplex jam 2 senso
1 sensor.
2. When opening the side door, the paper is detected
●
Troubleshooting method :
1 Open the side door Remove the jammed paper 1. Open the side door. Remove the jammed paper.
Close the side door. After warm up, if same jam occ
2. If there is any obstacles on duplex path, remove it.
3. If the feed roller is broken away, reassemble it.
4. Make the duplex 2 jam sensor be pushed by pushin
Close the side door.
Enter the diagnostic mode, and execute the duplex 2
Be the paper at sensor. If “Without paper” message
5. Check if the Side Joint PBA connector is connected
connector or replace the Side Joint PBA( JC95-011 connector or replace the Side Joint PBA( JC95 011
Service Manual
7-M
shooting
of duplex path.
or within a regular time after passing the duplex jam
d at the duplex jam 2 sensor.
curs, check the following.
g duplex gate and pulling down the timing belt.
2 jam sensor test.
is displayed, replace the sensor or the actuator.
properly. If there is any problem, reconnect the
125A ) 125A ).
SAMSUNG ELECTRONICS
M-9