Service Manual
Alignment & Adjustments
4-18
Samsung Electronics
4.4.3 Data Setup
SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
Caution :
The Send Fax Level is set to the best condition during manufacture. Never change settings arbitrarily.
DIAL MODE
This function can choose the dialing method.
*Default : Dial (Dial/Pulse)
MODEM SPEED
You can set the maximum modem speed.
When the fax establishes communication with a remote set the value of the maximum modem speed is
checked for both transmitter and receiver. The lowest value is used. It is best set at 33.6Kbps, the default
setting.
ERROR RATE
When the error rate is about exceed the set value, the Baud rate automatically adjusts to 2400 bps.
This ensures that the error rate remains below the set value.
You can select the rate between 5% and 10%.
CLEAR ALL MEMORY
The function resets the system to factory default settings.
This function is used to reset the system to the initial value when the product is functioning abnormally.
All the values are returned to the default values, and all the information which was set by the user
will be erased.
< Method >
1. Select the [MEMORY CLEAR] in TECH MODE.
2. Push the ENTER button.
3. Select your country. (There are four country groups. Refer to the table below.)
4. Push the ENTER button then it will clear all memory.
NOTICE :
Always perform a memory clear after replacing the main board, otherwise the system may
not operate properly.
Country Group
USA/Canada
UK
Russia
Southafrica
USA/Canada
UK
Russia
South Africa
Mexico
Germany
India
Brazil
France
Oman
Italy
Poland
Spain
Bangladesh
Austria
Kuwait
Netherlands
Moroco
Belgium
Algeria
Country
Portugal Pakistan
Sweden
UAE
Norway
Bahrain
Denmark
Srilanka
Finland
Saudi Arabia
Switzerland
Chile
Greece
Peru
Ireland
Argentina
Turkey
Hungary
Romania
Bulgaria
Czech
