Samsung MWR-WS00, Installation Manual

Page: 6 / 22

E-
6
Installing the Wired Remote Controller (Continued)
1 Open the wired remote controller by pushing up the top cover
of the remote controller while holding the rear cover firmly.
2
Install the rear cover of the wired remote controller on the wall
with the screws supplied.
3
Connect the red and blue wires from the wired remote
controller to the V1 and V2 terminal of the indoor unit.
(Use a separate wire if needed for distance.)
4 Connect the indoor unit housing with the wired remote controller
housing supplied with the wired remote controller and connect
to the yellow and orange cables from the wired remote controller
or connect the yellow and orange cables from the wired remote
controller to the wires from the F3 and F4 terminal of the indoor
unit depending on the indoor unit type.
5 Reassemble the wired remote controller.
Installation
Indoor unit
Wired
remote
controller
Cables
not supplied
Housing
Tighten the
cable with
the wire joint
(accessories)
tightly.
Indoor unit
Wired
remote
controller
Cables
not supplied
F3 F4
MWR-WS00_E_IM_25180.indd 6 2006-03-28 ｿﾀﾈﾄ 3:13:38