Samsung MWR-WS00, Installation Manual

Page: 11 / 22

E-
11
ENGLISH
Additional Functions
Service Mode
 
The wired remote controller supports the following service modes.
Menu
Description
1 Monitoring and setting the indoor unit option code
2 Monitoring and setting the indoor unit RMC address
3
Monitoring the indoor unit cycle data
4
Setting the indoor unit temperature sensor compensation
5
Setting the RPM compensation
6
Setting the EEV step when the indoor unit is off during
heating mode
7
Setting the filter time
8
Setting the heating capacity compensation
9
Checking the indoor unit centralized control switch setting
10
Checking the indoor unit drain pump switch setting
11
Checking the indoor unit electric heater switch setting
12 Checking the indoor unit hot water heater switch setting
 
If the option switch SW8 is set to ‘OFF’, the above service modes
can be only monitored. Set the option switch SW8 to ‘ON’ to set
the above service modes. In order to access the service mode,
hold down the ‘Hr.’ and ‘Min.’ buttons and the temperature down
button at the same time for 5 seconds.
Switch No.
Switch OFF Switch ON
SW8 Service mode monitor Service mode setup
�
��� ��� ��� ��� ��� ��� ��� ���
� � ��� � � � �
MWR-WS00_E_IM_25180.indd 11 2006-03-28 ｿﾀﾈﾄ 3:13:39