10
SYSTEM ADMINISTRATOR
PROGRAMMING
CUSTOMER LEVEL ACCESS
Before any customer programs can be accessed, you must first open sys-
tem programming using the passcode you have been assigned. You must
use a display keyset. Should it become necessary to change this passcode,
see your service company.
• While on-hook, press
TRSF
and then dial
200
.
Your display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four digit passcode.
The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial
1
to enable.
The display shows [ENABLE CUS. PROG - ENABLE].
• Press
TRSF
. The keyset returns to its idle condition.
• Press
TRSF
and then dial the three digit program code you want to
access. Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in
programming, any delay of more than 30 seconds between key strokes will
cause the system to automatically close programming.
CHANGING FEATURE PASSCODE
You can change individual feature passcodes. This program is used to
change the passcodes for several features. These features are the following:
RING PLAN SERVICE, DISA ALARM, ALARM CLEAR, and AA RECORD.
Note: Each passcode is four digits long. Each digit can be 0 to 9.
PROGRAM KEYS
UP
&
DOWN
- Select the extension number.
HOLD
- Press to reset the passcode to default settings.
Open customer programming and follow the instructions below.
ACTION
DISPLAY
1. Press
TRSF
and then dial
202
CHANGE PASSCODE
Display shows
RING PLAN: 0000
